ESP32S3用Arduino能连接但是超时导致烧录不上
开发板ESP32-S3-WROOM-1开发环境Arduino IDE报错Sketch uses 1057685 bytes (80%) of program storage space. Maximum is 1310720 bytes. Global variables use 48440 bytes (14%) of dynamic memory, leaving 279240 bytes for local variables. Maximum is 327680 bytes. Performing 1200-bps touch reset on serial port COM10 Waiting for upload port... No upload port found, using COM10 as fallback C:\Users\Schinee\AppData\Local\Arduino15\packages\esp32\tools\esptool_py\4.5.1/esptool.exe --chip esp32s3 --port COM10 --baud 115200 --before default_reset --after hard_reset write_flash -e -z --flash_mode dio --flash_freq 80m --flash_size 16MB 0x0 C:\DoraemonEnglishpath\arduino\sketches\1465729147234D1F579D52BB12E65CBB/conpet.ino.bootloader.bin 0x8000 C:\DoraemonEnglishpath\arduino\sketches\1465729147234D1F579D52BB12E65CBB/conpet.ino.partitions.bin 0xe000 C:\Users\Schinee\AppData\Local\Arduino15\packages\esp32\hardware\esp32\2.0.11/tools/partitions/boot_app0.bin 0x10000 C:\DoraemonEnglishpath\arduino\sketches\1465729147234D1F579D52BB12E65CBB/conpet.ino.bin esptool.py v4.5.1 Serial port COM10 Connecting... Chip is ESP32-S3 (revision v0.2) Features: WiFi, BLE Crystal is 40MHz MAC: 10:51:db:86:05:e4 Uploading stub... A fatal error occurred: Failed to write to target RAM (result was 01070000: Operation timed out) Failed uploading: uploading error: exit status 2我在烧录的时候发现超时烧录不上采取了以下解决方法1.查看配置是否正确2.打开设备管理器端口查看USB端口号是否对应3.开发板有两个口一个是USB供电一个是COM口传数据查看是否正确一般传数据用COM口4.换一根可以传数据的数据线5.按住Boot键强制烧录发现都没有用后我用采用U盘的方式烧录数据线连COM口从串口看数据1.数据线插在开发板USB的那个口Arduino下方会显示未连接没有关系2.配置如下烧录成功
